No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Hosts Cannot Receive Multicast Data

Hosts Cannot Receive Multicast Data

Fault Description

After Layer 3 multicast CAC is configured, hosts cannot receive multicast data.

Procedure

  • Run the display multicast limit global command to check whether the total number of multicast groups in the system reaches the global limit value.

    If the global limit value is reached, increase the global limit value to allow users to join new groups. Then run the display pim routing-table command to check whether new Protocol Independent Multicast (PIM) routing entries have been generated.

  • Run the display multicast limit out-interface command to check whether the number of multicast groups on outbound interfaces reaches the limit values configured on the interfaces.

    If the number of multicast groups on an interface reaches the configured limit, increase the limit value on this interface to allow users to join new groups. Then run the display pim routing-table command to check whether new PIM routing entries have been generated.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 42870

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next