No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic Multicast Network Management Function Configuration

Verifying the Basic Multicast Network Management Function Configuration

Procedure

  • Run the display snmp-agent trap feature-name igmp all command to check the status of the IGMP trap function.
  • Run the display snmp-agent trap feature-name mld all command to check the status of the MLD trap function.
  • Run the display snmp-agent trap feature-name mrm all command to check the status of the MRM trap function.
  • Run the display snmp-agent trap feature-name msdp all command to check the status of the MSDP trap function.
  • Run the display snmp-agent trap feature-name pim all command to check the status of the PIM trap function.
  • Run the display snmp-agent trap feature-name pim-std all command to check the status of the public PIM trap function.
  • Run the display snmp-agent trap feature-name l2-multicast all command to check the status of the Layer 2 multicast trap function.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46364

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next