No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
User Hosts in the User VLAN Fail to Receive Multicast Data

User Hosts in the User VLAN Fail to Receive Multicast Data

Fault Description

After VLAN-based multicast VLAN replication is configured, user hosts in the user VLAN cannot receive multicast data.


  • Check whether multicast VLAN replication is correctly configured.

    Run the display multicast-vlan vlan vlan-id command to check whether the user VLAN is bound to a correct multicast VLAN.

    • If the user VLAN is not bound to a correct multicast VLAN, run the multicast-vlan user-vlan command to bind VLANs correctly.
    • If the user VLAN is bound to a correct multicast VLAN, check whether other Layer 2 multicast configurations conflict.
      The following information shows that user VLANs 100 and 200 are bound to multicast VLAN 10 correctly.
      [HUAWEI] display multicast-vlan vlan 10
       Multicast-vlan         : 10
       User-vlan Number       : 2
       IGMP snooping state    : Enable
       MLD  snooping state    : Disable
       Prune-source-port state: Disable 
       User-vlan              Snooping-state
       100                     IGMP Enable /MLD Disable
       200                     IGMP Enable /MLD Disable

  • Check whether Layer 3 multicast forwarding is normal.

    Run the ping multicast host command to check whether Layer 3 multicast forwarding is normal. If Layer 3 multicast forwarding is abnormal, run the capture-packet { interface interface-type interface-number | acl acl-number } * command to obtain packet header information from the incoming multicast data flow on the inbound interface. Check the TTL value in the packet header.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46260

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next