No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Filtering MLD Messages Based on Source IPv6 Addresses

Filtering MLD Messages Based on Source IPv6 Addresses

Context

MLD runs between member hosts and the Layer 3 multicast device that is directly connected to the host network segment. A multicast device processes all received Report messages. To improve security and prevent multicast services from being affected by MLD messages maliciously forged by other devices, you can configure the switch to filter Multicast Listener Discovery (MLD) messages received on an interface. Messages that can be filtered include MLD Query messages, MLD Report and Done messages.

Before configuring MLD messages filtering based on source IPv6 addresses, configure an IPv6 access control list (ACL6) to define the range of source IPv6 addresses for packet filtering. For details about the ACL6 configuration, see ACL Configuration in the S7700 and S9700 V200R013C00 Configuration Guide - Security.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run mld query ip-source-policy { basic-acl6-number | acl6-name acl6-name }

    A policy is configured to filter MLD Query messages.

    By default, the switch does not filter Query messages and processes all the received Query messages.

    NOTE:

    When configuring an ACL6 rule for the interface, use the permit parameter to configure the interface to accept only Query messages with source addresses in a specified range. If no rule is configured in the ACL6, the interface discards Query messages from all source addresses.

  5. Run mld ip-source-policy { basic-acl6-number | acl6-name acl6-name }

    A policy is configured to filter Report/Done messages.

    By default, the switch does not filter Report/Done messages and processes all the received Report/Done messages.

    NOTE:

    When configuring an ACL6 rule for the interface, use the permit parameter to configure the interface to accept only Report and Done messages with source addresses in a specified range. If no rule is configured in the ACL6, the interface discards Report and Done messages from all source addresses.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 47131

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next