No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MLD SSM Mapping

MLD SSM Mapping

Source-Specific Multicast (SSM) requires multicast routers to know multicast sources that hosts specify when they join a multicast group. A host running MLDv2 can specify multicast source addresses in MLDv2 Report messages. Some hosts can run only MLDv1. To enable such hosts to obtain the SSM service, multicast routers need to provide the MLD SSM mapping function.

MLD SSM mapping is implemented based on static SSM mapping entries. A multicast router converts (*, G) information in MLDv1 Multicast Listener Report messages to (G, INCLUDE, (S1, S2...)) information according to static SSM mapping entries to provide the SSM service for MLDv1 hosts.

On the IPv6 SSM network shown in Figure 3-12, HostA runs MLDv1, while HostB runs MLDv2. If the MLD version of HostA cannot be upgraded to MLDv2, configure MLD SSM mapping on the router.

Figure 3-12  MLD SSM mapping

With SSM mapping entries configured, the router checks the multicast group address G in each received MLDv1 Report message, and processes the message based on the check result:
  • If G is out of the IPv6 SSM group address range, the router provides the ASM service.
  • If G is within the IPv6 SSM group address range:
    • If the router has no MLD SSM mapping entry matching G, it does not provide the SSM service and drops the Report message.
    • If the router has an MLD SSM mapping entry matching G, it converts (*, G) information in the Report message into (G, INCLUDE, (S1, S2...)) information and provides the SSM service for the hosts.
NOTE:

MLD SSM Mapping does not apply to MLDv2 Multicast Listener Report messages. To enable hosts running any MLD version on a network segment to obtain the SSM service, MLDv2 must run on interfaces of multicast routers on the network segment.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 47964

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next