No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv4 PIM Silent

Configuring IPv4 PIM Silent

Pre-configuration Tasks

Before configuring PIM Silent, complete the following task:

  • Configure a unicast routing protocol to ensure normal unicast routing on the network.
  • Enable PIM-SM.

Context

On the access layer, if the PIM protocol is enabled on the interfaces directly connected to user hosts, the interfaces can establish PIM neighbor relationships to process various PIM packets. The configuration, however, brings security risks. When a host maliciously sends many PIM Hello messages, the device may break down.

To prevent the preceding case, you can set the state of the device interface to PIM silent. When the interface is in PIM silent state, the interface is disabled from receiving and forwarding any PIM packet. All PIM neighbors and PIM state machines on the interface are deleted. The interface functions as the static DR and immediately takes effect. The PIM silent function does not affect the IGMP function on the interface.

PIM client takes effect on an interface only when the interface is directly connected to a user network segment and when the network segment is connected only to this PIM device.

  • After you configure PIM silent on an interface, the interface no longer receives or sends any PIM packets and other PIM functions on the interface become invalid. Confirm your action before configuring this function.

  • If a user network segment is connected to multiple devices and PIM silent is enabled on interfaces of multiple devices, the interfaces become static DRs. This results in multicast faults.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run pim silent

    The PIM silent function is enabled.

Verifying the Configuration

After PIM silent is configured, you can check information about the PIM interface.

Run the display pim [ vpn-instance vpn-instance-name | all-instance ] interface [ interface-type interface-number | up | down ] [ verbose ] command to check PIM information on an interface.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 43662

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next