No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Multicast Service Models

Multicast Service Models

Multicast service models differ for receiver hosts but do not affect multicast sources. A multicast source sends multicast packets by using its own IP address as the source IP address and a group address as the destination IP address. There are two multicast models: any-source multicast (ASM) and source-specific multicast (SSM). The two models use multicast group addresses in different ranges.

ASM Model

The ASM model distributes multicast data based on group addresses. A group address identifies a collection of network services. Multicast packets sent from any source to this address obtain the same services. After joining a group, a host can receive multicast data sent from any source with this group address as the destination address.

For security purposes, multicast source filter policies can be configured on routers to permit or deny packets from specific multicast sources. This filters data sent to receiver hosts.

In the ASM model, each group address must be unique on the entire multicast network. An ASM group can only be used by a single application at a time. If two applications use the same ASM group, receiver hosts of the two applications receive traffic from both application sources. In this case, the network will be congested and the receiver hosts cannot function normally.

SSM Model

The SSM model provides service for data flows from specific sources to a specific group. Receiver hosts can specify the sources from which they want to receive data when they join a group. After joining the group, the hosts receive only the data sent from the specified sources.

The SSM model does not require globally unique group addresses, but each group address must be unique to a multicast source. Different applications on a source must use different SSM groups. Different applications on different sources can reuse SSM group addresses because each source-group pair has an (S, G) entry. This model saves multicast group addresses without congesting the network.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 42201

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next