No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Aging Time of Dynamic Router Ports

Setting the Aging Time of Dynamic Router Ports


Router ports send Report messages to upstream Layer 3 multicast devices and receive multicast data packets from upstream devices. After MLD snooping is configured on a switch, the switch dynamically learns router ports and monitors upstream multicast data forwarding in real time. When network congestion or flapping occurs, dynamic router ports cannot receive Internet Group Management Protocol (IGMP) General Query or Protocol Independent Multicast (PIM) Hello messages before it times out. The switch then deletes these router ports from the router port list, causing service interruption. To prevent this problem, set a longer aging time.


  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run mld-snooping router-aging-time router-aging-time

    The aging time is configured for dynamic router ports.

    By default, the aging time of router ports learned from MLD Query messages is 180 seconds and the aging time of those learned from PIM Hello messages is the Holdtime value in PIM Hello packets.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 47795

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next