No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Multicast Group Policy

Configuring a Multicast Group Policy

Context

A multicast group policy determines which multicast groups the hosts in a VLAN can join. The multicast group policy is applicable only to dynamic multicast groups. Before configuring the multicast group policy, create an access control list (ACL) and define rules. For details about ACL configuration, see ACL Configuration in the S7700 and S9700 V200R013C00 Configuration Guide - Security.

NOTE:

The ACL referenced in a group policy denies all multicast groups by default. Therefore, to reject multicast data sent to specific groups, use a rule permit source any rule with deny rules in the ACL.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vsi vsi-name

    The virtual switching instance (VSI) view is displayed.

  3. Run igmp-snooping group-policy acl-number [ version version-number ]

    A multicast group policy is configured in the VSI.

    By default, user hosts in a VSI can join any multicast group. If the IGMP version is not specified for a multicast group policy, the switch applies the policy to all received IGMP messages regardless of version.

Verifying the Configuration

After configuring a multicast group policy, you can run the following commands in any view to check the IGMP snooping configuration and forwarding entries.

  • Run the display igmp-snooping [ vsi [ vsi-name ] ] configuration command to check the IGMP snooping configuration.
  • Run the display l2-multicast forwarding-table vsi [ vsi-name ] [ group-address { group-address | router-group } ] command to check the multicast forwarding table in a VSI.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46261

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next