No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the MLD Version

Configuring the MLD Version

Context

A multicast switch can identify Multicast Listener Discovery (MLD) messages of a version earlier than its own MLD version but cannot identify MLD messages of a later version. To ensure normal MLD operation, ensure that the switch runs the same MLD version as receiver hosts or a later MLD version.

If there are multiple multicast switches on a shared network segment of hosts, all host-side interfaces of these multicast switches must run the same MLD version. If they are running different MLD versions, MLD cannot function normally on the network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run mld version { 1 | 2 }

    The MLD version is specified for the interface.

    By default, an interface runs MLDv2 after MLD is enabled on the interface.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 44018

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next