No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for IGMP Snooping

Application Scenarios for IGMP Snooping

Network Description

In Figure 11-7, multiple multicast sources, such as Source1 and Source2, exist on a PIM network. The sources provide multicast video services for users on the LAN. HostA and HostC want to receive video data in multicast mode. To prevent multicast data from being broadcast on the LAN, IGMP snooping needs to be configured on the Layer 2 switch to accurately forward multicast data on the Layer 2 network. This prevents bandwidth waste and network information leakage.

Figure 11-7  IGMP snooping network

Deployed Features

You can deploy the following features to accurately forward multicast data on the network shown in Figure 11-7:

  • PIM and IGMP on the Layer 3 multicast router to route multicast data to user segments.
  • IGMP snooping on the Layer 2 switch to set up and maintain a Layer 2 multicast forwarding table, based on which multicast data can be forwarded to specified users.
  • IGMP snooping proxy (after configuring IGMP snooping) on the switch to release the router from processing a large number of IGMP messages.
  • IGMP snooping SSM mapping on the switch to provide the SSM service for hosts running IGMPv1 or IGMPv2.

    Layer 2 SSM mapping must be combined with Layer 3 SSM mapping on the IGMP querier to ensure multicast data forwarding. You must configure Layer 3 SSM mapping entries on the IGMP querier.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46297

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next