No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Multicast VPN Running Status

Monitoring the Multicast VPN Running Status

Context

During routine maintenance, you can run the following commands in any view to monitor the running status of IPv4 multicast VPN.

Procedure

  • Run the display multicast-domain vpn-instance vpn-instance-name share-group [ local | remote ] command to check the Share-Group information of a specified VPN.
  • Run the following commands to check the Switch-Group information of a specified VPN instance:

    • display multicast-domain vpn-instance vpn-instance-name switch-group receive brief

    • display multicast-domain vpn-instance vpn-instance-name switch-group receive [ active | group group-address | sender source-address | vpn-source-address [ mask { source-mask-length | source-mask } ] | vpn-group-address [ mask { group-mask-length | group-mask } ] ] *

  • Run the display multicast-domain vpn-instance vpn-instance-name switch-group send [ group group-address | reuse interval | vpn-source-address [ mask { source-mask-length | source-mask } ] | vpn-group-address [ mask { group-mask-length | group-mask } ] ] * command to check the Switch-Group information of a specified VPN instance.
  • Run the display multicast-domain { vpn-instance vpn-instance-name | all-instance } control-message counters command to check the statistics about the messages received and sent by a specified VPN instance.
  • Run the display multicast-domain { vpn-instance vpn-instance-name | all-instance } invalid-packet command to check the statistics about the invalid messages received by a specified VPN instance.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46399

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next