No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring SA Caching

Configuring SA Caching


To shorten the delay before obtaining multicast information, enable the SA caching function. The switch then caches (S, G) entities obtained from SA messages. When the switch receives a new Join message, it searches the local cache for the (*, G) entry carried in the message:

  • If the matching (S, G) entry is found, the switch adds the sender of the Join message to the shortest path tree (SPT) with source S as the root.
  • If no matching (S, G) entry is found, the switch must wait the SA message sent by the MSDP peer during the next period.

As (S, G) entries accumulate in the cache, a larger memory space is occupied. You can set the maximum number of (S, G) entries allowed in the cache to protect the switch against Denial of Service (DoS) attacks.


  1. Run system-view

    The system view is displayed.

  2. Run msdp [ vpn-instance vpn-instance-name ]

    The MSDP view is displayed.

  3. Run cache-sa-enable

    The SA caching function is enabled.

    By default, the SA caching function is enabled on the switch that has a remote MSDP peer specified.

  4. (Optional) Run peer peer-address sa-cache-maximum sa-limit

    The maximum number of (S, G) entries is set.

    By default, a maximum of 8192 (S, G) entries can be saved in the SA cache.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 42281

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next