No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding User VLANs to a Multicast VLAN

Binding User VLANs to a Multicast VLAN


A user VLAN can be bound to a multicast VLAN on a user-side interface. A user VLAN cannot be bound to more than one multicast VLAN on the same interface.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run l2-multicast-bind vlan vlan-id1 [ to vlan-id2 ] mvlan mvlan-id

    User VLANs are bound to a multicast VLAN on the interface.

    If you want to configure Layer 2 multicast Call Admission Control (CAC) on an interface after you bind a user VLAN to a multicast VLAN on the interface, pay attention to the following points:
    • Do not configure a limit on the number of groups on the interface.
    • When configuring a limit on the number of groups in a VLAN on the interface, ensure that the VLAN is not the user VLAN or multicast VLAN.

    For details about Layer 2 multicast CAC, see Layer 2 Multicast CAC Configuration.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 54921

Downloads: 48

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next