No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling Software Forwarding for IPv6 Multicast Packets

Disabling Software Forwarding for IPv6 Multicast Packets

Pre-configuration Tasks

Before disabling soft forwarding for IPv6 multicast packets, complete the following tasks:

  • Configure an IPv6 unicast routing protocol to ensure normal unicast routing on the IPv6 network.
  • Run the multicast ipv6 routing-enable command in the system view to enable Layer 3 IPv6 multicast routing globally.

Context

In most cases, the switch forwards packets based on software before the hardware forwarding is completed. Then, the switch forwards packets based on hardware. Soft forwarding for multicast packets must be disabled on the switch to prevent packet loss and disorder caused by the low forwarding speed and first packet cache mechanism of soft forwarding.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run multicast ipv6 cpu-forward disable

    Software forwarding is disabled for IPv6 multicast packets.

    By default, software forwarding for IPv6 multicast packets is enabled.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 42869

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next