No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

Context

To control the range of multicast groups that hosts on an interface's network segment can join, use an access control list (ACL) to filter Membership Report messages received on the interface. This ACL allows the switch to maintain only memberships of the interface in these multicast groups. For details on how to configure an ACL, see ACL Configuration in the S7700 and S9700 V200R013C00 Configuration Guide - Security.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run igmp group-policy { acl-number | acl-name acl-name } [ 1 | 2 | 3 ]

    An ACL is applied to specify the range of multicast groups that the interface can join.

    By default, an interface can join any multicast groups.

    NOTE:

    When configuring an ACL rule for an interface, use the permit parameter in the rule command to allow hosts connected to the interface to join groups within the specified range. If no rule is configured in the ACL, hosts connected to the interface cannot join any groups.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 48012

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next