No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic MLD Snooping Configuration

Verifying the Basic MLD Snooping Configuration

Context

After the configurations are complete, run the following commands in any view to check MLD snooping configurations, member ports, and router ports.

Procedure

  • Run the display mld-snooping [ vlan vlan-id ] configuration command to check MLD snooping configuration.
  • Run the display mld-snooping [ vlan vlan-id ] command to check running parameters of MLD snooping.
  • Run the display mld-snooping port-info [ vlan vlan-id [ group-address ipv6-group-address ] ] [ verbose ] command to check member ports of a multicast group.
  • Run the display mld-snooping router-port [ vlan vlan-id ] command to check router ports.
  • Run the display mld-snooping forwarding-table vlan [ vlan-id ] [ [ source-address source-ipv6-address ] group-address { group-ipv6-address | router-group } ] command to check the multicast forwarding table in a VLAN.
  • Run the display l2-multicast forwarding-mode vlan [ vlan-id ] command to check multicast data forwarding mode in the VLAN.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 42346

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next