No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MLD

Enabling MLD

Context

IPv6 multicast routing is the prerequisite for configuring all IPv6 multicast functions. You must enable IPv6 multicast routing before configuring an IPv6 multicast protocol.

Before configuring Multicast Listener Discovery (MLD) on a multicast switch, enable MLD on an interface connected to receiver hosts.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Run set multicast forwarding-table super-mode

    The high specification mode is configured for multicast forwarding.

    In large-scale multicast applications, the switch generates a large number of MLD group entries. When the number of MLD group entries reaches the default limit, new MLD group entries cannot be generated. The high specification mode increases the number of MLD group entries supported on the switch. After this mode is configured, the number of MLD group entries can reach the maximum number supported by the switch, maximizing the switch's capability to support large-scale multicast applications.

    NOTE:
    • The configuration of high specification mode takes effect after a restart.

    • After the high specification mode is configured, the default value of the robustness variable changes from 2 to 3.

  3. Run multicast ipv6 routing-enable

    IPv6 multicast routing is enabled.

  4. Run interface interface-type interface-number

    The interface view is displayed.

  5. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  6. Run mld enable

    MLD is enabled on the interface.

    By default, MLD is disabled on an interface.

    NOTE:

    If IPv6 PIM and MLD need to be enabled on the same interface, enable IPv6 PIM and MLD in sequence.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 42329

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next