No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of Multicast VLAN Replication Configuration Tasks

Summary of Multicast VLAN Replication Configuration Tasks

Multicast VLAN replication can be configured in different methods depending on the application scenario. Table 14-1 lists multicast VLAN replication configuration tasks.

Table 14-1  Multicast VLAN replication configuration tasks
Task Description

Configuring Multicast VLAN Replication Based on User VLANs

When user VLAN-based multicast VLAN replication is configured on a switch, the upstream device only needs to send one copy of multicast data to the switch. The switch then replicates multicast data and sends the data to multiple user VLANs. This saves bandwidth between the upstream device and the switch.

Configuring Interface-based Multicast VLAN Replication

By binding user VLANs to a multicast VLAN on a user-side interface, you can implement multicast service isolation on the interface while allowing multicast data replication to user VLANs. For example, when multiple ISPs provide multicast services on a network, you can configure this function to ensure that data of an ISP is forwarded only to the users who have subscribed to the services of the ISP.

Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 46816

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next