No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R013C00

This document describes the configurations of IP multicast, including IP multicast basics, IGMP, MLD, IPv4 PIM, IPv6 PIM, MSDP, multicast VPN, layer 3 multicast CAC, IPv4 multicast route management, IPv6 multicast route management, IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, layer 2 multicast CAC, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting the Interval for Sending PIM Trap Messages

Adjusting the Interval for Sending PIM Trap Messages

Context

After Protocol Independent Multicast (PIM) is enabled on a switch, you can set the PIM-MIB notification interval to determine the interval at which PIM events are reported. In this way, you can monitor various PIM events on the switch, including neighbor loss, presence of new neighbors, invalid Join/Prune messages received, RP-mapping changes, DR elected on an interface, failures to join multicast groups because the number of PIM entries reaches the limit, and invalid Register messages received.

Perform the following steps on the switch managed by the network management system.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run multicast-mib

    The multicast MIB view is displayed.

  3. Run pim mib-notification interval { interface-election-dr election-value | invalid-join-prune jp-value | invalid-register register-value | neighbor-loss loss-value | new-neighbor new-value | rp-mapping-change change-value | mrt-limit mrt-value }

    The interval for sending PIM trap messages is set.

    By default, the interval for sending trap messages about neighbor loss and new neighbor presence events is 0 seconds. That is, a trap message is sent immediately when such an event occurs.

    The default interval for sending trap messages about invalid Join/Prune messages, RP-mapping changes, DR elected on an interface, failures to join multicast groups because the number of PIM entries reaches the limit, and invalid Register messages is 65535 seconds. That is, no trap messages are sent when these events occur.

    NOTE:

    To configure PIM to report these events, run the pim mib-notification interval command to set an interval smaller than 65535 seconds.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065742

Views: 47670

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next