No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S7700 and S9700 V200R013C00

This document describes the configurations of IP service, including IP address, ARP, DHCP, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Link-local Addresses for Interfaces

Configuring Link-local Addresses for Interfaces

Context

Link-local addresses are used in neighbor discovery or stateless autoconfiguration. An IPv6 link-local address is generated by either of the following methods:

  • Generated automatically: A device automatically generates a link-local address for an interface based on the link-local prefix (FE80::/10) and link layer address of the interface.
  • Configured manually: You can manually configure an IPv6 link-local address for an interface.
NOTE:
  • Each interface can be configured with only one link-local address. To prevent link-local address conflict, automatically generated link-local addresses are recommended. After an interface is configured with an IPv6 global unicast address, it automatically generates a link-local address.

  • Manually configured link-local addresses have a higher priority than automatically generated ones. Manually configured addresses can overwrite automatically generated ones, but automatically generated addresses cannot overwrite manually configured ones. If manually configured addresses are deleted, the automatically generated ones that were previously overwritten take effect again.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ipv6

    IPv6 packet forwarding is enabled.

    By default, IPv6 packet forwarding is disabled.

  3. Run interface interface-type interface-number

    The specified interface view is displayed.

  4. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  5. Run ipv6 enable

    The IPv6 function is enabled on the interface.

    By default, the IPv6 function is disabled on an interface.

  6. Run either of the following commands to configure a link-local address for an interface:

    • Run ipv6 address ipv6-address link-local

      A link-local address is configured for an interface.

    • Run ipv6 address auto link-local

      A link-local address is automatically generated.

Verifying the Configuration

  • Run the display ipv6 interface [ interface-type interface-number | brief ] command in any view to check IPv6 information about a specified interface.

  • Run the display this ipv6 interface command in the interface view to check IPv6 information about the current interface.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065743

Views: 26373

Downloads: 31

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next