No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S7700 and S9700 V200R013C00

This document describes the configurations of IP service, including IP address, ARP, DHCP, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Switch to Fragment Outgoing IP Packets

Configuring the Switch to Fragment Outgoing IP Packets

Context

During actual packet forwarding, the length of an IP packet may exceed the MTU value. When the remote device or intermediate forwarding device receives IP packets, if it checks the packet length and discards packets whose length is longer than the Maximum Transmission Unit (MTU) on the interface, network communication is interrupted. In this case, fragmentation for outgoing IP packets can be configured so that the system fragments the packets. In this way, all IP packets can be forwarded properly.

Procedure

  • Configure fragmentation for outgoing forwarding-plain IP packets.
    1. Run system-view

      The system view is displayed.

    2. Run ipv4 fragment enable

      Fragmentation is enabled for outgoing forwarding-plain IP packets.

      By default, fragmentation for outgoing forwarding-plain IP packets is disabled.

      NOTE:

      This command takes effect only for the forwarding-plain packets but not for the control-plain packets.

      This command takes effect only on the X series cards.

  • Configure fragmentation for outgoing control-plain IP packets
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run clear ip df

      The fragmentation is enabled for outgoing control-plain IP packets.

      By default, fragmentation for outgoing control-plain IP packets on an interface is disabled.

      NOTE:

      This command takes effect only for the control-plain packets but not for the forwarding-plain packets.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065743

Views: 27284

Downloads: 31

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next