No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Service

S7700 and S9700 V200R013C00

This document describes the configurations of IP service, including IP address, ARP, DHCP, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static Neighbors

Configuring Static Neighbors


To communicate with a destination host, a host needs to obtain the destination host's link-layer address. The link-layer address of a neighbor node can be obtained using the neighbor discovery mechanism, or by manually configuring static neighbor entries. A device identifies a static neighbor entry based on the IPv6 address of this neighbor and number of the Layer 3 interface connected to this neighbor. To filter invalid packets, you can create static neighbor entries, binding the destination IPv6 addresses of these packets to nonexistent MAC addresses.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The specified interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run ipv6 enable

    The IPv6 function is enabled.

  5. Run the following commands to configure static neighbors based on the interface type.

    • For the Ethernet interface, run the ipv6 neighbor ipv6-address mac-address command.

    • For a VLANIF interface, run the ipv6 neighbor ipv6-address mac-address vid vlan-id interface-type interface-number


Updated: 2019-04-20

Document ID: EDOC1100065743

Views: 26381

Downloads: 31

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next