No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S7700 and S9700 V200R013C00

This document describes the configurations of IP service, including IP address, ARP, DHCP, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Tunnel Route

Configuring a Tunnel Route

Context

Packets can be forwarded correctly only when devices at the two ends of a tunnel are configured with forwarding routes. Perform the following configurations on devices at each end of the tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip route-static ip-address { mask | mask-length } tunnel interface-number

    A static route is configured.

    The static route must be configured on both ends of the tunnel.

    NOTE:

    The destination address of the static route is the destination IPv4 address of the packets that are not encapsulated into IPv6 packets, and the next hop is the local tunnel interface.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100065743

Views: 29266

Downloads: 31

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next