No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the IS-IS Auto FRR Configuration

Verifying the IS-IS Auto FRR Configuration

Prerequisites

All IS-IS Auto FRR configurations are complete.

Procedure

  • Run the display isis route [ process-id | vpn-instance vpn-instance-name ] [ ipv4 ] [ verbose | [ level-1 | level-2 ] | ip-address [ mask | mask-length ] ] * command to check information about the primary link and backup link after IS-IS Auto FRR is enabled.
  • Run the display isis spf-tree [ systemid systemid | dname dname ] [ [ level-1 | level-2 ] | ipv6 | verbose ] * [ process-id | vpn-instance vpn-instance-name ] command to check the traffic protection type of IS-IS Auto FRR.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 56162

Downloads: 46

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next