No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPF IP FRR Configuration

Verifying the OSPF IP FRR Configuration

Prerequisites

All OSPF IP FRR configurations are complete.

Procedure

  • Run the display ospf [ process-id ] routing command to check information about the primary and backup links after OSPF IP FRR is enabled.

    View the routes to the specified OSPF device.

    <HUAWEI> display ospf routing 192.168.4.0
    
             OSPF Process 1 with Router ID 192.168.150.11
    
     Destination : 192.168.4.0/24     
     AdverRouter : 10.4.4.4                 Area      : 0.0.0.0  
     Cost        : 2                        Type      : Transit 
     NextHop     : 192.168.2.2              Interface : Vlanif20  
     Priority    : Low                      Age       : 00h00m10s  
     Backup Nexthop : 192.168.1.2           Backup Interface: Vlanif10
     Backup Type : LFA LINK

    The preceding information shows that a backup route is generated on the switch, including information about the backup next hop: Backup NextHop, Backup Interface, and Backup Type indicating the address, outbound interface, and type of the backup next hop respectively.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 66880

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next