No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Extended Community Filter

Configuring an Extended Community Filter


You can use an extended community filter when using the route target (RT) attribute to filter routes in a VPN.


  1. Run system-view

    The system view is displayed.

  2. Run ip extcommunity-filter { basic-extcomm-filter-num | basic basic-extcomm-filter-name } { deny | permit } { rt { as-number:nn | 4as-number:nn | ipv4-address:nn } } &<1-16>

    Or run ip extcommunity-filter { advanced-extcomm-filter-num | advanced advanced-extcomm-filter-name } { deny | permit } regular-expression

    An extended community filter is configured.

Verifying the Configuration

Run the display ip extcommunity-filter [ basic-extcomm-filter-num | advanced-extcomm-filter-num | extcomm-filter-name ] command to check information about a configured extended community filter.

Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 66679

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next