No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Output of IS-IS Adjacency Status

Configuring the Output of IS-IS Adjacency Status


On an IS-IS network, neighbor flapping will result in network instability and frequent network convergence. This will consume lots of memory and may even cause user traffic loss. Therefore, neighbor flapping needs to be rapidly located and solved.

To rapidly locate problems in the case of neighbor flapping, enable the output of IS-IS adjacency changes to log these changes.

If the local terminal monitor is enabled and the output of the IS-IS adjacency status is enabled, IS-IS adjacency changes will be output to the router until the output of the adjacency status is disabled.


  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    The IS-IS view is displayed.

  3. Run log-peer-change [ topology ]

    The output of the adjacency status is enabled.

    By default, the output of IS-IS adjacency changes is disabled.

Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 66689

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next