No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic OSPF Functions

Configuring Basic OSPF Functions

Applicable Environment

When OSPF is configured on multiple switches in the same area, most configuration data, such as the timer, filter, and aggregation, must be planned uniformly by area. Incorrect configurations may prevent neighboring switches from exchanging information or even cause routing information congestion and self-loops.

OSPF configurations performed in interface views take effect regardless of whether OSPF is enabled. These configurations remain in place even if OSPF is disabled.

Pre-configuration Tasks

Before configuring basic OSPF functions, configure IP addresses for interfaces to ensure that neighboring nodes are reachable at the network layer.

Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 65990

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next