No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an IS-IS Process

Creating an IS-IS Process

Context

Creating an S-IS process is the prerequisite for performing the IS-IS configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    An IS-IS process is created, and the IS-IS process view is displayed.

    The process-id parameter specifies the ID of an IS-IS process. The default process ID is 1.

  3. (Optional) Run description description

    A description for the IS-IS process is configured.

  4. (Optional) Enable IS-IS to add the POI and hostname TLV to Purge LSPs.

    Run purge-originator-identification enable [ always ]

    IS-IS is enabled to determine whether to add the POI TLV and hostname TLV to Purge LSPs based on the authentication configuration.

    • If the purge-originator-identification enable command is run and the any authentication is configured, generated Purge LSPs do not carry the POI TLV or hostname TLV.

    • If the purge-originator-identification enable command is run and no authentication is configured, generated Purge LSPs carry the POI TLV or hostname TLV.

    • If the purge-originator-identification enable always command is run, generated Purge LSPs carry the POI TLV and hostname TLV, regardless of whether authentication is configured.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 66670

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next