No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an LSA Transmission Delay

Configuring an LSA Transmission Delay

Context

LSAs age in the LSDB of a local switch but do not age in the transmission process. Set a delay for LSA transmission. This is a necessary configuration for low-speed networks.

Perform the following operations on the switch that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run ospfv3 trans-delay interval [ instance instance-id ]

    A delay for LSA transmission is set on the interface.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 67005

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next