No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the BGP Route Selection and Load Balancing Configuration

Verifying the BGP Route Selection and Load Balancing Configuration

Procedure

  • Run the display bgp paths [ as-regular-expression ] command to check BGP AS_Path information.
  • Run the display bgp routing-table different-origin-as command to check the routes with the same destination address but different origin ASs.
  • Run the display bgp routing-table regular-expression as-regular-expression command to check information about routes that match the AS regular expression.
  • Run the display bgp routing-table [ ipv4-address [ { mask | mask-length } [ longer-prefixes ] ] ] command to check routing information in a BGP routing table.
  • Run the display bgp routing-table community [ community-number | aa:nn ] &<1-29> [ internet | no-advertise | no-export | no-export-subconfed ] * [ whole-match ] command to check routing information with the specified BGP community.
  • Run the display bgp routing-table community-filter { { community-filter-name | basic-community-filter-number } [ whole-match ] | advanced-community-filter-number } command to check information about routes matching a specified BGP community filter.
  • Run the display bgp multicast routing-table [ ip-address [ mask-length [ longer-prefixes ] | mask [ longer-prefixes ] ] ] command to check the MBGP routing table.
  • Run the display bgp multicast routing-table statistics command to check statistics about the MBGP routing table.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 66772

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next