No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of Static Route Configuration Tasks

Summary of Static Route Configuration Tasks

You can accurately control route selection on a network by configuring static routes. If static route functions other than route selection control are required, configure them according to reference sections. Table 2-1 describes static route configuration tasks.

Table 2-1  Static route configuration tasks




Configuring static routes

Static routes are manually configured by administrators to ensure normal operations of simple networks and required bandwidth for important network applications.

Configuring fault detection protocols for static routes

In actual networking, static routes are associated with fault detection protocols to improve network performance.

Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 75409

Downloads: 60

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next