No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic RIP Functions

Configuring Basic RIP Functions

Pre-configuration Tasks

Before configuring basic RIP functions, configure IP addresses for interfaces to ensure network-layer communication between neighbor nodes.

Configuration Procedure

You must enable RIP before specifying the network segment where RIP runs and configuring RIP neighbors and RIP version on an NBMA network.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 65238

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next