No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring GR Session Parameters on the Restarter

(Optional) Configuring GR Session Parameters on the Restarter


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF view is displayed.

  3. Run graceful-restart [ period period | planned-only | partial ] *

    GR session parameters are set on the Restarter.

    • The parameter period indicates the GR period on the Restarter. By default, the GR period is 120 seconds.
    • The parameter planned-only indicates that the Restarter supports only planned GR. By default, the Restarter supports both planned GR and unplanned GR.
    • The parameter partial indicates that the Restarter supports only partial GR. By default, the Restarter supports totally GR.

Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 65973

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next