No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an SPF Timer

Configuring an SPF Timer

Context

When the OSPFv3 LSDB changes, SPF calculation must be performed again. A shorter SPF calculation interval can increase network convergence speed, but also occupies more resources. In addition, frequent network changes can cause excessive bandwidth use. A longer SPF calculation interval occupies fewer resources, which prevents the bandwidth use due to frequent network changes. However, this also decreases network convergence speed. Set the interval based on actual network conditions.

Perform the following operations on the switch that runs OSPFv3.

Procedure

  • Configure an SPF normal timer.
    1. Run system-view

      The system view is displayed.

    2. Run ospfv3 [ process-id ]

      The OSPFv3 view is displayed.

    3. Run spf timers delay-interval hold-interval

      Or run spf-schedule-interval delay-interval hold-interval

      An SPF normal timer is configured.

  • Configure an SPF intelligent timer.
    1. Run system-view

      The system view is displayed.

    2. Run ospfv3 [ process-id ]

      The OSPFv3 view is displayed.

    3. Run spf-schedule-interval intelligent-timer max-interval start-interval hold-interval-1

      An SPF intelligent timer is configured.

      NOTE:

      The configurations of the spf timers delay-interval hold-interval, spf-schedule-interval delay-interval hold-interval, and spf-schedule-interval intelligent-timer max-interval start-interval hold-interval-1 commands will override each other, and only the configuration of the last executed command takes effect.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 58153

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next