No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for OSPF

Default Settings for OSPF

Table 5-18 describes the default settings for OSPF.

Table 5-18  Default settings for OSPF
Parameter Default Setting
OSPF Disabled
Interval for sending Hello packets 10 seconds on P2P and broadcast interfaces; 30 seconds on P2MP and NBMA interfaces
Dead interval after which an OSPF neighbor relationship expires 40 seconds on P2P and broadcast interfaces; 120 seconds on P2MP and NBMA interfaces
Period during which a device acts as a stub router 500 seconds
Bandwidth reference value used to calculate a link cost 100 Mbit/s
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 64475

Downloads: 50

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next