No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BGP Route Dampening

Configuring BGP Route Dampening

Context

A route is considered to be flapping when it repeatedly appears and then disappears in the routing table. BGP generally applies to complex networks where routes change frequently. Frequent route flapping consumes lots of bandwidths and CPU resources and even affects normal network operation. BGP route dampening prevents frequent route flapping.

BGP can differentiate routes based on policies and use different route dampening parameters to suppress different routes. For example, on a network, you can set a long suppression time for routes with a long mask and set a short suppression time for routes with a short mask (such as 8-bit mask).

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Enter the corresponding address family view based on network type to configure BGP devices on networks.

    • Run ipv4-family { unicast | multicast | vpnv4 [ unicast ] | vpn-instance vpn-instance-name }

      The IPv4 address family view is displayed.

    • Run ipv6-family [ unicast | vpn-instance vpn-instance-name ]

      The IPv6 address family view is displayed.

  4. Run dampening [ ibgp ] [ half-life-reach reuse suppress ceiling | route-policy route-policy-name ] *

    BGP route dampening parameters are configured.

    NOTE:

    The dampening command is valid only for EBGP routes.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 67088

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next