No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD for IPv4 Static Routes

Configuring Static BFD for IPv4 Static Routes

Pre-configuration Tasks

Before configuring static BFD for IPv4 static routes, complete the following tasks:

  • Configure link layer parameters and IP addresses for interfaces to ensure network-layer communication between neighbor nodes.

  • Configure a BFD session.

    For details, see BFD Configuration in the S7700 and S9700 V200R013C00 Configuration Guide - Reliability.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip route-static ip-address { mask | mask-length } { nexthop-address | interface-type interface-number [ nexthop-address ] } [ preference preference | tag tag ] * track bfd-session cfg-name [ description text ]

    An IPv4 static route on a public network is associated with a BFD session.

    NOTE:

    Before associating a static route with a BFD session, ensure that the BFD session and static route are on the same link.

    When a BFD session is associated with VRRP or a static route, by default, the system does not allow the associated BFD session to be deleted. To delete the associated BFD session, run the bfd session nonexistent-config-check disable command to prevent the device from checking whether the associated BFD session is deleted. Note that deleting the BFD session will prevent the configured association function from being implemented.

Verifying the Configuration

Run the following command to check the previous configuration.

  • Run the display bfd session all [ verbose ] command to check information about the BFD session.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 59162

Downloads: 48

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next