No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R013C00

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring P2MP Network Attributes

Configuring P2MP Network Attributes

Procedure

  1. Disable OSPF from checking the network mask.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run ospf network-type p2mp

      A network type is configured for the OSPF interface.

      A P2MP network must be forcibly changed from another network type. For details, see Configuring Network Types for OSPF Interfaces.

    5. Run ospf p2mp-mask-ignore

      OSPF is disabled from checking the network mask on the P2MP network.

    6. Run quit

      Exit the interface view.

  2. (Optional) Set the cost for the OSPF route to a specified neighbor on a P2MP network.

    By default, on a P2MP network, the cost of an OSPF route to a neighbor equals the interface cost. If this default cost is not suitable, run the p2mp-peer command to set a desired cost.

    1. Run ospf [ process-id ]

      The OSPF process view is displayed.

    2. Run p2mp-peer ip-address cost cost

      A cost is set for an OSPF route to a specified neighbor on a P2MP network.

  3. Configure the switch to filter the LSA packets to be sent.

    When multiple links exist between two switches, you can configure the local switch to filter the LSA packets to be sent. This can reduce unnecessary LSA retransmission attempts and save bandwidth resources.

    1. Run ospf [ process-id ]

      The OSPF process view is displayed.

    2. Run filter-lsa-out peer ip-address { all | { summary [ acl { acl-number | acl-name } ] | ase [ acl { acl-number | acl-name } ] | nssa [ acl { acl-number | acl-name } ] } * }

      The local switch is configured to filter the LSA packets to be sent on the P2MP network.

      By default, the LSA packets to be sent are not filtered.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065744

Views: 57522

Downloads: 46

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next