No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the CR-LSP Backup Configuration

Verifying the CR-LSP Backup Configuration

Prerequisites

The configurations of CR-LSP backup are complete.

Procedure

  • Run the display mpls te tunnel-interface [ tunnel tunnel-number ] command to check information about the tunnel interface.
  • Run the display mpls te hot-standby state { all [ verbose ] | interface tunnel interface-number } command to check information about the hot-standby status.
  • Run the display mpls te tunnel [ destination ip-address ] [ lsp-id ingress-lsr-id session-id local-lsp-id ] [ lsr-role { all | egress | ingress | remote | transit } ] [ name tunnel-name ] [ { incoming-interface | interface | outgoing-interface } interface-type interface-number ] [ verbose ] command to check CR-LSP information.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20511

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next