No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static Routes

Configuring Static Routes

Context

Using static routes is the simplest method for importing traffic to an MPLS TE tunnel.

Procedure

Static routes in an MPLS TE tunnel are similar to common static routes. You only need to configure a static route with a TE tunnel interface as the outbound interface. For detailed instructions, see Configuring IPv4 Static Routes in "Static Route Configuration" in the S7700 and S9700 V200R013C00 Configuration Guide - IP Unicast Routing.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 33182

Downloads: 35

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next