No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Tunnel Policy

Configuring a Tunnel Policy

Context

In general, VPN traffic is forwarded through an LSP tunnel but not an MPLS TE tunnel. To import VPN traffic to the MPLS TE tunnel, you need to configure a tunnel policy.

Procedure

You can configure either of the following types of tunnel policies according to service requirements:
  • Tunnel type prioritizing policy: Such a policy specifies the sequence in which different types of tunnels are selected by the VPN. For example, you can specify the VPN to select the TE tunnel first.
  • Tunnel binding policy: This policy binds a TE tunnel to a specified VPN by binding a specified destination address to the TE tunnel to provide QoS guarantee.

For detailed instructions, see Configuring and Applying a Tunnel Policy in "BGP/MPLS IP VPN Configuration" in the S7700 and S9700 V200R013C00 Configuration Guide - VPN.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 26842

Downloads: 33

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next