No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Establishing LDP Remote Peers on the Two Ends of the TE Tunnel

Establishing LDP Remote Peers on the Two Ends of the TE Tunnel


To configure LDP over TE, create remote LDP peers on both ends of a TE tunnel. Perform the following steps on the ingress and egress of a TE tunnel:


  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp remote-peer remote-peer-name

    The view of the MPLS LDP remote peer is displayed.

  3. Run remote-ip ip-address

    The IP address of the remote LDP peer is configured.

    By default, the IP address of the remote LDP peer is not configured.

Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 26358

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next