No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Tunnel Priority

Configuring the Tunnel Priority

Context

In the process of establishing a CR-LSP, if no path with the required bandwidth exists, you can perform bandwidth preemption according to setup priorities and holding priorities.

Perform the following configurations on the ingress node of an MPLS TE tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    The tunnel interface view of the MPLS TE tunnel is displayed.

  3. Run mpls te priority setup-priority [ hold-priority ]

    The priority for the tunnel is configured.

    Both the setup priority and the holding priority range from 0 to 7. The smaller the value is, the higher the priority is.

    By default, both the setup priority and the holding priority are 7. If only the setup priority value is set, the holding priority value is the same as the setup priority value.

    NOTE:

    The setup priority should not be higher than the holding priority. So the value of the setup priority must not be less than that of the holding priority.

  4. Run mpls te commit

    The current tunnel configuration is committed.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 23737

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next