No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Administrative Group and Affinity Property

Configuring Administrative Group and Affinity Property

Context

The configuration of the administrative group affects only LSPs to be set up; the configuration of the affinity property affects established LSPs by recalculating the paths.

Perform the following configurations on the ingress node of an MPLS TE tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view of the MPLS-TE-enabled interface is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run mpls te link administrative group value

    The administrative group of the MPLS TE link is configured.

    The modification of administrative group takes effect only on LSPs that are established after modification.

  5. Run quit

    Return to the system view.

  6. Run interface tunnel interface-number

    The tunnel interface view of the MPLS TE tunnel is displayed.

  7. Run mpls te affinity property properties [ mask mask-value ] [ secondary | best-effort ]

    The affinity for the tunnel is configured.

    By default, the values of administrative group, affinity property, and mask are all 0x0.

    After the modified affinity property is committed, the established LSP in this tunnel may be affected and the system recalculates the path for the TE tunnel.

  8. Run mpls te commit

    The current tunnel configuration is committed.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20160

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next