No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Manual TE FRR

Configuring Manual TE FRR

Manual TE FRR is a local protection mechanism used on MPLS TE networks. TE manual FRR switches traffic on a primary MPLS TE tunnel to a manually configured bypass tunnel if a link or node on the primary tunnel fails.

Pre-configuration Tasks

Before configuring manual MPLS TE FRR, complete the following tasks:
  • Configure a dynamic MPLS TE tunnel. For details, see Configuring a Dynamic MPLS TE Tunnel.
  • Enable MPLS, MPLS TE and RSVP-TE in the system view and interface view of each node along a bypass tunnel.
  • Enable CSPF on a PLR.
NOTE:

Perform the operation of Configuring Dynamic BFD for RSVP to implement fast switching at the millisecond level.

Configuration Procedure

Except that configuring a TE FRR scanning timer and changing the PSB and RSB timeout multiplier are optional, other configurations are mandatory.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20349

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next