No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling LDP over TE

Enabling LDP over TE

Context

LDP over TE can be enabled on the ingress of a TE tunnel.

In LDP over TE networking, switches do not support load balancing. Therefore, when multiple TE tunnels are configured on an MPLS TE network, LDP LSP service traffic can be transmitted only through the TE tunnel that first delivers entries.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp

    The MPLS-LDP view is displayed.

  3. Run ldp-over-te enable

    LDP over TE is enabled.

    By default, LDP over TE is not enabled.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 23738

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next