No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Dynamic BFD to Monitor a BGP Tunnel

Verifying the Configuration of Dynamic BFD to Monitor a BGP Tunnel

Prerequisites

The dynamic BFD for BGP tunnel function has been configured.

You can view BGP BFD session information on the ingress of the BGP tunnel.

Procedure

  • Run the display mpls bfd session protocol bgp [ fec fec-address [ verbose ] ] command to check information about a BFD session with the protocol type of BGP on the ingress on an E2E BGP tunnel.
  • Run the display mpls lsp protocol bgp verbose command to check the BFD session status of BGP LSPs.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 20352

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next