No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R013C00

This document describes the configurations of MPLS, including Static LSP, MPLS LDP, MPLS QoS, MPLS TE, MPLS OAM, Seamless MPLS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of Static LSPs

Overview of Static LSPs

Static LSPs are manually set up by an administrator and apply to networks with simple and stable network topologies. They cannot be set up using a label distribution protocol.

As shown in Figure 2-1, the path through which IP packets are transmitted on an MPLS network is called label switched path (LSP). An LSP can be manually configured or established using label distribution protocols.

Figure 2-1  Networking of MPLS

Generally, MPLS uses the Label Distribution Protocol (LDP) to set up LSPs. LDP uses routing information to set up LSPs. If LDP does not work properly, MPLS traffic may be lost. Static LSPs are configured to determine the transmission path of some key data or important services.

A static LSP is set up without using any label distribution protocol to exchange control packets, so the static LSP consumes few resources. However, a static LSP cannot vary with the network topology dynamically, and must be adjusted by an administrator according to the network topology. The static LSP applies to networks with simple and stable network topologies.

When configuring a static LSP, the administrator needs to manually allocate labels for each Label Switching Router (LSR) in compliance with the following rule: the value of the outgoing label of the previous node is equal to the value of the incoming label of the next node.

In Figure 2-1, a static LSP is set up on the backbone network so that L2VPN or L3VPN services can be easily deployed.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065745

Views: 23689

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next